Error code · Whirlpool

What you will see

• Display goes blank or shows partial segments
• Buttons stop responding
• F6E2 then F6E3 alternating

Most likely causes, in order

Listed from the most common and cheapest to check, to the least common and most expensive. Work down the list — do not jump to the last item because it is the one that sounds serious.

1. A momentary communication glitch, often after a power flicker
2. Loose harness connector between the UI and the ACU
3. Moisture in the control area

Safe checks you can do

1. Unplug the washer, or switch the breaker off.
2. Leave it unpowered for a full 5 minutes so the boards fully discharge.
3. Restore power and check whether the display comes up clean.
4. Run one short cycle to confirm the code does not return.

When to call a technician

The code persists after a full 5-minute power-down. The harness or a board needs service.

Also call if you see or smell burning, if the breaker trips when the washer starts, or if water has reached any electrical part. Those are stop-now conditions, not check-it-later conditions.

Models that show F6E2

We confirmed F6E2 in the published troubleshooting table for these models:

• WTW8000D
• MVWB965H

The code is defined for the shared washer platform, so a sibling model can display it even when its own manual does not list it.

Other Whirlpool codes

• Whirlpool F1E1 error code The main control board (ACU) reported an internal fault
• Whirlpool F2E5 error code The user interface panel and the main control board do not match
• Whirlpool F3E1 error code The washer cannot read the water level
• Whirlpool F5E2 error code The lid lock will not engage

Related symptom guides

• Washer won't drain
• Washer won't spin
• Washer won't fill
• Washer won't start