Maytag MHW3500F Common Problems & Recalls

This page covers the Maytag MHW3500F, a 4.5 cu ft front load washer first listed with ENERGY STAR in 2016-06. It lists the failure modes the machine is actually built to have — the parts Maytag publishes replacements for — plus the recall status and whether a repair is worth the money.

Recall status

No public recall record for this model. We check the CPSC recall database for the brand and model string. No record means no recall has been published for the MHW3500F — it does not mean the design is flawless. If a recall is issued later, it will appear here.

What actually fails on this machine

Maytag publishes 10 replacement parts for the MHW3500F. That list is the honest answer to “what goes wrong”: a part only gets a published replacement number if people are buying it. These are the categories:

System	What you notice	Typical repair
Drain Pump	Washer will not drain, standing water	Replace the part; check the harness and connector at the same time
Hose Clamp	Small leak at hose connection	Replace the part; check the harness and connector at the same time
Hinge	Component failure	Replace the part; check the harness and connector at the same time
Front Load Washer Bellow	Component failure	Replace the part; check the harness and connector at the same time
Detergent Dispenser	Detergent not dispensing	Replace the part; check the harness and connector at the same time
Dryer Cap	Component failure	Replace the part; check the harness and connector at the same time
Water Level Switch	Component failure	Replace the part; check the harness and connector at the same time
Lid Lock / Latch	Washer will not start	Replace the part; check the harness and connector at the same time

These are the failure paths this model is provisioned for, not a count of complaints. We do not publish invented failure rates.

Error codes this family reports

Maytag does not publish error-code definitions for the MHW3500F in the owner's manual, so we do not list any for it. The codes below belong to the same washer platform and are documented for sibling models — treat them as indicators of what this machine may report, not as a confirmed code list.

F1E1 The main control board (ACU) reported an internal fault
F2E3 The user interface and the main control board failed to initialize together
F3E1 The washer cannot read the water level
F5E2 The lid lock will not engage
F5E3 The lid lock will not release
F6E2 The user interface panel cannot talk to the main control board
F6E3 Same communication failure as F6E2 — the UI and main control board are out of sync
F8E1 The washer is taking too long to fill
F8E6 The lid was left open
F9E1 The washer is taking too long to drain
LF Long Fill
dr Drain problem — the washer cannot empty the drum in the time allowed
drn Drain problem, long form of the same display message as dr

Is it worth repairing?

The rule most appliance technicians use: if the repair costs more than half the price of a new machine, and the washer is over eight years old, replace it. Two specific cases change that maths.

A shaking or noisy washer is often a levelling or installation problem, not a part. Fix that first — it costs nothing.
A washer that will not drain is usually a blocked hose, which is also free to check.
A control board or sealed drum failure is where the maths usually says replace the machine.

When it is a technician job, not a DIY job

Stop and call a licensed technician if any of these apply:

The machine has a burning smell, scorch marks or a tripping breaker.
Water has reached the control board or any mains wiring.
The repair needs the drum, transmission or tub seal opened up.
The appliance is gas-fired and the fault is anywhere near the gas train.
You are not confident working with 120 V wiring while standing on a wet floor.

Sibling models with the same platform

More for the MHW3500F

How the MHW3500F differs from its closest siblings

These are the models most often confused with the MHW3500F. The differences below are computed from our own records, not copied from a marketing sheet.

vs MHW8150E

8 kWh/yr less energy (79 vs 87)
29 gal/yr more water (4,239 vs 4,210)
3 part numbers fit only this model (WPW10605427, W11106747, WPW10365885)
3 part numbers fit only the MHW8150E

Shared: both front load; 4.5 cu ft drum; 7 of 10 part numbers identical.

vs MHW5630H

41 kWh/yr more energy (128 vs 87)
57 gal/yr more water (4,267 vs 4,210)
6 part numbers fit only this model (WPW10605427, W11106747, WPW10365885, WP285655, WPW10448876, WPW10443885)
6 part numbers fit only the MHW5630H
8 variants listed for the MHW5630H vs 2 here

Shared: both front load; 4.5 cu ft drum; 4 of 10 part numbers identical.

Where this data comes from

Recall databasehttps://www.cpsc.gov/Recallschecked 2026-10-26
Error code definitionshttps://producthelp.whirlpool.com/Product_Help_Page?model=MHW3500FW0checked 2026-10-26
Replacement partshttps://www.partselect.com/Models/MHW3500F/checked 2026-10-26

3 separate sources are listed above; each field on this page traces to one of them. We publish facts we can point to — no republished manual text, no hosted PDFs, no invented model numbers or error codes.