Whirlpool WFW92HEF Common Problems & Recalls

This page covers the Whirlpool WFW92HEF, a 4.5 cu ft front load washer first listed with ENERGY STAR in 2016-06. It lists the failure modes the machine is actually built to have — the parts Whirlpool publishes replacements for — plus the recall status and whether a repair is worth the money.

Recall status

No public recall record for this model. We check the CPSC recall database for the brand and model string. No record means no recall has been published for the WFW92HEF — it does not mean the design is flawless. If a recall is issued later, it will appear here.

What actually fails on this machine

Whirlpool publishes 10 replacement parts for the WFW92HEF. That list is the honest answer to “what goes wrong”: a part only gets a published replacement number if people are buying it. These are the categories:

System	What you notice	Typical repair
Drain Pump	Washer will not drain, standing water	Replace the part; check the harness and connector at the same time
Hose Clamp	Small leak at hose connection	Replace the part; check the harness and connector at the same time
Hinge	Component failure	Replace the part; check the harness and connector at the same time
Washer Water Inlet Flowmeter	Component failure	Replace the part; check the harness and connector at the same time
Dryer Cap	Component failure	Replace the part; check the harness and connector at the same time
Water Level Switch	Component failure	Replace the part; check the harness and connector at the same time
Lid Lock / Latch	Washer will not start	Replace the part; check the harness and connector at the same time
Door Strike	Door will not stay closed	Replace the part; check the harness and connector at the same time

These are the failure paths this model is provisioned for, not a count of complaints. We do not publish invented failure rates.

Error codes this family reports

Whirlpool does not publish error-code definitions for the WFW92HEF in the owner's manual, so we do not list any for it. The codes below belong to the same washer platform and are documented for sibling models — treat them as indicators of what this machine may report, not as a confirmed code list.

F1E1 The main control board (ACU) reported an internal fault
F2E5 The user interface panel and the main control board do not match
F3E1 The washer cannot read the water level
F5E2 The lid lock will not engage
F5E3 The lid lock will not release
F6E2 The user interface panel cannot talk to the main control board
F6E3 Same communication failure as F6E2 — the UI and main control board are out of sync
F8E1 The washer is taking too long to fill
F8E6 The lid was left open
F9E1 The washer is taking too long to drain
LF Long Fill
dr Drain problem — the washer cannot empty the drum in the time allowed
drn Drain problem, long form of the same display message as dr

Is it worth repairing?

The rule most appliance technicians use: if the repair costs more than half the price of a new machine, and the washer is over eight years old, replace it. Two specific cases change that maths.

A shaking or noisy washer is often a levelling or installation problem, not a part. Fix that first — it costs nothing.
A washer that will not drain is usually a blocked hose, which is also free to check.
A control board or sealed drum failure is where the maths usually says replace the machine.

When it is a technician job, not a DIY job

Stop and call a licensed technician if any of these apply:

The machine has a burning smell, scorch marks or a tripping breaker.
Water has reached the control board or any mains wiring.
The repair needs the drum, transmission or tub seal opened up.
The appliance is gas-fired and the fault is anywhere near the gas train.
You are not confident working with 120 V wiring while standing on a wet floor.

Sibling models with the same platform

More for the WFW92HEF

How the WFW92HEF differs from its closest siblings

These are the models most often confused with the WFW92HEF. The differences below are computed from our own records, not copied from a marketing sheet.

vs WFW7540F

1 kWh/yr less energy (88 vs 89)
2 part numbers fit only this model (WPW10110225, WPW10488048)
2 part numbers fit only the WFW7540F
1 variants listed for the WFW7540F vs 4 here

Shared: both front load; 4.5 cu ft drum; 8 of 10 part numbers identical.

vs WFW4720R

51 kWh/yr more energy (140 vs 89)
38 gal/yr more water (4,248 vs 4,210)
9 part numbers fit only this model (WPW10605427, WPW10208415, WP285655, WPW10110225, WPW10208398, WPW10448876, WP3359452, WPW10443885, WPW10488048)
9 part numbers fit only the WFW4720R
1 variants listed for the WFW4720R vs 4 here

Shared: both front load; 4.5 cu ft drum; 1 of 10 part numbers identical.

Where this data comes from

Recall databasehttps://www.cpsc.gov/Recallschecked 2026-10-26
Error code definitionshttps://producthelp.whirlpool.com/Product_Help_Page?model=WFW92HEFW0checked 2026-10-26
Replacement partshttps://www.partselect.com/Models/WFW92HEF/checked 2026-10-26

3 separate sources are listed above; each field on this page traces to one of them. We publish facts we can point to — no republished manual text, no hosted PDFs, no invented model numbers or error codes.